Fibaro Universal Dimmer

Product Overview

Remotely controlled light dimming module FIBARO Dimmer 2 is designed to work with various types of light sources. It may be connected to two-wire or three-wire configuration so it can operate with or without neutral lead. FIBARO Dimmer 2 can switch or dim connected light source either through radio waves or through the wall switch connected directly to it.

New FIBARO Dimmer 2 is equipped with an algorithm of smart light source detection which makes configuration easier and ensures high compatibility of the device. It may be used as a switch with non-dimmable light sources (in 3-wire connection).

Remotely controlled light dimming module FIBARO Dimmer 2 is designed to work with various types of light sources. It may be connected to two-wire or three-wire configuration so it can operate with or without neutral lead. FIBARO Dimmer 2 can switch or dim connected light source either through radio waves or through the wall switch connected directly to it.

New FIBARO Dimmer 2 is equipped with an algorithm of smart light source detection which makes configuration easier and ensures high compatibility of the device. It may be used as a switch with non-dimmable light sources (in 3-wire connection).

  • Compatible with any Z-Wave or Z-Wave+ Controller
  • Advanced microprocessor control
  • Implemented algorithm of smart light source detection
  • Auto-adjustment of the appropriate control mode to connected load
  • Active power and energy metering functionality
  • Soft start function
  • Memory of the last lighting level settings
  • Works with various types of switches – momentary, toggle, three-way, etc.
  • Active element: semiconductor electronic switch
  • To be installed in wall switch boxes of dimensions allowing for installation, conforming to provisions of applicable regulations
  • FGD-212 is an extension unit
Power supply 100-240 V~ 50/60 Hz
Power consumption < 1.3W
Operational temperature 0-35°C
Dimensions (L x W x H) 42.5 x 38.25 x 20.3 mm
For installation in boxes Ø ≥ 50mm
Operational current 0.25-1.1A
Device temperature protection 105°C
Over current protection required external 10A circuit breaker
Active element semiconductor electronic switch ε
Device control remotely – radio waves
directly – external switch
Radio protocol Z-Wave
Radio signal power up to 1mW
Radio frequency 865.2 MHz 
Range up to 50 m outdoors
up to 30 m indoors
(depending on building materials)
Comply with EU directives RED 2014/53/EU
RoHS 2011/65/EU
Book an Appointment